Miten yhdistää Maxisys Pro VCI? by Angelababy Li

Through USB connection

USB connection is the most fast and convenient communication between MaxiSys

diagnostic equipment and Maxisys Pro VCI equipment.

Flat diagnostic equipment via USB connection line Maxisys Pro VCI equipment

connected. At the bottom of the screen the Maxisys Pro VCI find

air press button will display a green the “tick” icon in a few seconds, also Maxisys

Pro VCI equipment on the USB led instructions indicator lamp

will light up, said equipment witch the connection is successful.

Note: while using two communication modes at the same time, the MaxiSys system

will choose to the use of USB communication automatically.

4.1.3 no communication tips

If the MaxiSys tablet diagnostic equipment not successfully connected Maxisys Pro

VCI device, the screen will display a “wrong” information.

“The wrong information” means tablet diagnostic equipment has no mornam

communication with Maxisys Pro VCI equipment, Therefore it can

not go into the vehicle control module. You need to check the following measures in

such case.

If you use it firstly time

In the case of using a wireless connection, check weather the network configuration

is correct or not , or weather the paired devices correctly or not.

If the diagnosis process, due to the loss of signal communication, suddenly broken,

check whether the object caused by signal interference.

And check the Maxisys Pro VCI equipment is correctly positioned, Maxisys Pro VCI

devices should be placed upside down on.

as close as possible to the Maxisys Pro VCI device to benefit from a more stable and

faster the speed of communication signal.

In the case of using a wired connection, check the diagnosis of tablet devices and

VCI devices between the cable connection is good.

check the Maxisys Pro VCI device of the blue Shao ring USB indication lamp is lit.

– check equipment Maxisys Pro VCI the fault indication lamp is lit. Fault indication

lights said equipment that might exist between communication

mistakes, then you can try to reconnect the device. If the return loss method is

invalid, it may said the hardware of the equipment in the presence

of faults, in returning the case need to contact technical support.

if the Maxisys Pro VCI device is unable to establish normal communications,

a message appears on the screen. The possible reasons for the

problem are as follows:

The Maxisys Pro VCI device can not establish the communication connection of

vehicle.

The vehicle is not equipped with the selected test system.

The vehicle Maxisys Pro VCI ring joint loose mai.

– vehicle fuse.

Fault or joint – vehicle wiring, data line.

The data line ring joint circuit fault.

– the vehicle identification code is not correct input.

4.2 The first time use

When using the diagnostic application for the first time, the Maxisys Pro VCI device

must not MaxiSys diagnostic devices to establish synchronous

communications connections.

That’s all which we shared the Maxisys Pro VCI with you today,For more information

about Maxisys Pro,You can contact our sales by [email protected]

or visit our official website : www.getautel.com